基于平面度的燃料电池电化学性能模拟

 固体氧化物燃料电池的翘曲会影响电极-盖板界面的接触情况，从而影响电化学性能，对相关制造工艺提出了很大的挑战．为了分析燃料电池平面度对放电过程的影响，揭示其潜在的风险，我们建立了两个基于有限元法的仿真模型，对考虑平面度缺陷的燃料电池封装和放电进行分析．在对固体氧化物燃料电池进行平面度测量的基础上，首先建立了具有真实燃料电池翘曲特性的几何模型，分析封装过程中接触压力的分布情况．然后将接触电阻的仿真结果导入到三维多物理场耦合模型中，模拟具有平面度缺陷的燃料电池电化学性能．计算结果展示了燃料电池两侧封装过程中接触压力的分布情况．通过对比有接触电阻和无接触电阻的燃料电池电流密度，分析了电池与盖板的接触对放电过程的影响．结果表明，燃料电池的凹陷面较难达到满意的接触状态，需要比凸起面更大的封装压力．燃料电池表面接触电阻的变化将引起电流传导路径的变化，产生局部高电流或低电流．这项工作强调了在燃料电池中保持均匀分布的接触电阻的重要性，为今后的优化工作奠定了基础．     

Information percolation and cutoff for the random‐cluster model

We consider the random‐cluster model (RCM) on with parameters p∈(0,1) and q ≥ 1. This is a generalization of the standard bond percolation (with edges open independently with probability p) which is biased by a factor q raised to the number of connected components. We study the well‐known Fortuin‐Kasteleyn (FK)‐dynamics on this model where the update at an edge depends on the global geometry of the system unlike the Glauber heat‐bath dynamics for spin systems, and prove that for all small enough p (depending on the dimension) and any q>1, the FK‐dynamics exhibits the cutoff phenomenon at with a window size , where λ_∞ is the large n limit of the spectral gap of the process. Our proof extends the information percolation framework of Lubetzky and Sly to the RCM and also relies on the arguments of Blanca and Sinclair who proved a sharp mixing time bound for the planar version. A key aspect of our proof is the analysis of the effect of a sequence of dependent (across time) Bernoulli percolations extracted from the graphical construction of the dynamics, on how information propagates.     

基于CARS技术的超燃冲压发动机点火过程温度测量

相干anti-Stokes Raman散射（coherent anti-Stokes Raman scattering，CARS）技术作为一种非接触测量手段，已广泛应用于多种发动机模型燃烧室温度测量及地面试验.然而，目前的工作主要集中在稳态燃烧场温度的测量，缺乏用高分辨率的单脉冲来测量瞬变的燃烧火焰温度及组分浓度的研究.基于CARS理论，结合多参数拟合算法，开发了基于MATLAB的CARS光谱计算和拟合程序CARSCF；利用McKenna平面火焰炉在不同工况下进行了温度测量，并与DLR测量结果进行对比，结果显示开发的CARSCF具有较高的测量重复性和准确性；最后将CARS技术应用于测量超燃冲压发动机点火过程中的温度测量，获取了点火过程中的温度.结果显示，在来流Mach数为3的条件下，H₂/air点火过程中温度呈现急剧上升然后缓慢下降，而CARS信号则呈现急剧上升然后急剧下降随后又缓慢上升的趋势，并且在点火过程中最高温度为1 511 K.      

Synthesis and characterization of VO–vanillin complex immobilized on MCM-41 and its facile catalytic application in the sulfoxidation reaction,and synthesis of 2,3-dihydroquinazolin-4(1H)-ones and disulfides in green media

In this work, a vanillin complex is immobilized onto MCM-41 and characterized by FT-IR, X-ray diffraction, scanning electron microscopy, energy dispersive spectroscopy, thermogravimetric analysis, and BET techniques. This supported Schiff base complex was found to be an efficient and recoverable catalyst for the chemoselective oxidation of sulfides into sulfoxides and thiols into their corresponding disulfides (using hydrogen peroxide as a green oxidant) and also a suitable catalyst for the preparation of 2,3-dihydroquinazolin-4(1H)-one derivatives in water at 90°C. Using this protocol, we show that a variety of disulfides, sulfoxides, and 2,3-dihydroquinazolin-4(1H)-one derivatives can be synthesized in green conditions. The catalyst can be recovered and recycled for further reactions without appreciable loss of catalytic performance.     

Methane dissolution inside bulk or porous-medium-confined water at near-hydrate equilibrium conditions

In this study, we perform a series of mass-balance-type calculations, in order to estimate the minimum volume of liquid water required to dissolve completely a single methane gas bubble, located inside different types of domains that are near or under hydrate equilibrium pressure/temperature conditions. We examine the case of methane bubble dissolution in the bulk, along with the cases of methane bubble dissolution within simple/regular networks of pores, where all pores have the same size. In our calculations, we consider experimental values for the equilibrium solubilities of methane in water, along the hydrate-forming line, as well as, values obtained from predictive tools that are based on different thermodynamic models. The effect of aqueous NaCl solutions on the results is also investigated. As a result of the relatively low solubility of methane in water, large volumes of water are required for complete dissolution of a methane bubble.     

强度解调型光纤光栅温度传感实验

光纤光栅在工程上应用广泛,但由于存在解调系统复杂、成本高,尤其是需要使用光纤光谱仪等波长解调仪器,使得光纤光栅很难走入本科教学的实验课堂.本文提出了一种基于窄线宽DFB激光器的强度解调方案,极大地简化了光纤光栅传感器的解调系统,完全满足较高分辨率和实时检测的系统要求.合理安排的温度传感实验可以非常直观地展示光纤光栅的线性传感性能,使得工程化的光纤光栅传感技术轻松走进本科教学课堂,具有极高的推广和应用潜力.     

高盐样品中锂的电感耦合等离子体发射光谱法(ICP-OES)测定研究

锂是重要的战略金属和新能源材料,其开发利用受到全球的高度关注。在高盐卤水特别是盐湖卤水和地下卤水中富含巨量的锂资源,在对这些资源进行锂的开发利用过程中,需对锂的含量进行准确测定,然而卤水中共存的高浓度Na+, K+, Ca2+和Mg2+会对微量锂的准确测定产生严重的干扰。电感耦合等离子体发射光谱法(ICP-OES)具有线性范围宽和多元素同步分析能力,针对卤水中锂的快速准确测定,详细开展了高盐样品中锂的ICP-OES分析方法研究。结果表明,锂在610.364 nm处具有较高的信噪比,且Na+, K+, Ca2+, Mg2+和Ar不会对锂的测定产生显著的谱线干扰。然而,样品中大量共存的Na+, K+和Mg2+会对锂的测定产生严重的基体正干扰,而Ca2+产生负干扰。尽管内标法在消除基体干扰方面具有广泛的应用,但传统的以钇和钪为内标元素的内标法不能有效解决该问题。此外,针对标准加入法操作繁琐、不适合批量样品分析问题,以及基体匹配法需多离子匹配,且不适合样品基体组成变化的批量样品分析等问题,考察了采用单一组分进行复杂基体匹配的可行性。由于NaCl广泛存在于卤水中,且对锂的测定具有显著的增敏效应,通过系列研究发现,通过同时向样品和标准溶液中加入10 g·L-1的NaCl,成功解决了总量不超过40 g·L-1的NaCl, KCl和MgCl2所产生的干扰。尽管采用该法或沉淀预分离方式均不能消除Ca2+产生的负干扰,但当样品中Ca2+含量不高于1.8 g·L-1时,对测定不产生显著的影响。通过采用该方法对三种不同基体组成的卤水样品进行加标回收测定,其回收率在96.60%~104.20%范围内。此外,通过与电感耦合等离子体质谱法(ICP-MS)测定结果进行对比,充分论证了该法的准确性和可靠性(相对误差±3.66%)。该法仅以单一的NaCl进行复杂基体匹配,不仅简化了操作,还实现了基体组成变化的批量样品分析,因而在卤水中锂的快速准确测定及锂资源开发利用方面具有重要意义。     

A solvent-governed surface state strategy for rational synthesis of N and S co-doped carbon dots with multicolour fluorescence

ABSTRACT

Multicolour emissive carbon dots (CDs) are widely investigated by virtue of their merits on fluorescent properties. Method on heteroatom doping assisted with various solvents has been proved efficient in achieving multiple-colour-emissive CDs, especially long-wavelength emission. Herein, a synthesis of multicolour-emissive CDs by controlled surface function is reported. By tuning the thermal-pyrolysis temperature and molar ratio of reactants, optimal emission of the resulted CDs gradually shifts from blue to yellow light with the assistance of different solvents. According to the emissive relationship dependent on excitation, fluorescence lifetimes, and FT-IR of these CDs, the different surface states participated with S and N elements on the surface of carbogenic core govern fluorescent colours of the CDs. In terms of the applications, blue CDs (B-CDs) exhibits high sensitivity for ion detections of Ag⁺ and Fe³⁺, which is further illustrated to have different quenching mechanisms each other because that these ions have the affinity interaction with different surface groups of the CDs. Moreover, blue and yellow CDs solutions are mixed with PVP water solution to fabricate white-light CDs/PVP film, which exhibits stable fluorescence with a CIE coordinate of (0.32, 0.33) and endows these CDs as potentially fluorescent nanomaterial in the solid state lighting field.     

Size reduction of “reformed casein micelles” by high-power ultrasound and high hydrostatic pressure

We investigated the effect of ultrasound (US) and high hydrostatic pressure (HHP) on the size of reformed casein micelles (RMCs) obtained by titrating calcium and phosphorous solution into sodium caseinate solutions. Both US and HHP reduced the size of the RMCs. A decrease in size from ~200 nm to ~170 nm when US (20 kHz, 0.46 W/mL) was applied for 30 min; and down to ~85 nm when HHP was applied 500 MPa for 15 min. Electron microscopic analysis showed that the RMCs before and after US are similar to milk native casein micelles, and that HHP extensively disintegrated the RMCs. Small angle X-ray scattering and SDS-PAGE showed that the internal structure of the RMCs as well as the casein molecules are not affected by the US and HHP treatments.